News and Start Page.
Is your old distributor cap showing its age ? Cracked and worn ! A lot cheaper alternative is to replace it with a Beamspark ignition unit and distributor blanking cap with a modern twin output coil.
UK delivery post free the next day. Very easy to fit !
See pictures below which shows the distributor mounted as it would be on the engine, with the adjustment flange at mid point. See FOR SALE page.
************* New page added. Distributor internals.*********************
Two years no quibble guarantee as well.
-----------------------------------------------------------------------------------------
Post free in the UK. Ten £ (pounds) sterling international, This is 50 % off !
------------------------------------------------------------------------
New polished distributor cap shown below. I manufacture the distributor cap in batches of ten. Each one takes approximately one day of machining on a small lathe, then milling operations and finally drilling and tapping. A two coat finish in satin black or natural finish satin aluminium of your choice.
Shown below the all new Mark 3 Beamspark ( see start page for details and offer )

Showing the distributor as it would be mounted on the engine, but now the contact breaker plate is reversed so points are at the top making adjustment and timing much easier. ( If oil seal fails on distributor shaft the points do not get covered in oil ). The distributor cap has a drain hole at bottom. Full written and pictorial instructions are supplied with the kit.
Reversing the points plate is simply a matter of removing the two slotted head screws and rotating the plate 180 degrees.
The white wire is shown connected directly to the points underneath the plastic 'tophat'. The wire and support loop are supplied as part of the kit.